Now insert our 10k ohm resistor into the 5V rail and the breadboard rail connected to our top pin on our push button. Insert the push button into the middle of the breadboard splitting the legs into the left and right rows. Red LED to pin 3, yellow LED to pin 4, green LED to pin 5, blue LED to pin 6 and white LED to pin 7. Now wire each LED anode to its corresponding pin on the Arduino. Next insert a 1k ohm resistor on each LED cathode connecting them to the ground rail on our breadboard. First off insert all 5 of the LED's into the left side of the breadboard making sure that each LED leg gets its own row on the breadboard. To start with our wiring you can visit my Tinkercad Circuit I designed were you can interact with this circuit online and view the wiring needed to complete this circuit.